I have a Bombardier Outlander 400 that I want to add a battery tender/charger to. The battery location is such that you can’t use alligator clips to put a regular charger on. It is an ordeal to even remove it. I’ve looked at a few tenders and some come with a wire that has eyelets to attach to the battery, a fuse and quick connect plug to attach to the tender unit. I can zip tie that lead and make it easily accessible for use. Any brands that I should try or brands to avoid. Most all I’ve seen are fully automatic and can be left on for extended periods of time.
ATVs
Battery tender/charger
Displaying 1 to 11 of 11 posts
To be clear, an AGM battery is a SLA or sealed lead acid battery.
Quote:
AGM (Absorbed Glass Mat) refers to a specific type of SLA/VRLA where the electrolyte is absorbed into separators between the plates consisting of sponge like fine glass fiber mats. SLA batteries are divided up into specific subsets of batteries.
I've been an ATV mechanic since the early eighties so if you have a dependable modern battery charger, you can leave it attached 24/7 365 but there isn't any real benefit compared to periodic charging. Batteries by nature are design to store electrical energy.
Quote:
AGM (Absorbed Glass Mat) refers to a specific type of SLA/VRLA where the electrolyte is absorbed into separators between the plates consisting of sponge like fine glass fiber mats. SLA batteries are divided up into specific subsets of batteries.
I've been an ATV mechanic since the early eighties so if you have a dependable modern battery charger, you can leave it attached 24/7 365 but there isn't any real benefit compared to periodic charging. Batteries by nature are design to store electrical energy.
The battery I have in the ATV is a Yuasa brand AGM. It is a match for the factory original which lasted from 2004-2018. To remove and replace the battery is a difficult task as you need to tip and roll it on its end then side. A wet cell battery would likely leak during that process as while it is in the non upright position you have to unhook or hook up the positive wire.
I use trickle chargers with the pig tail connections. I have them on my ATVs and riding lawnmower. No alligator clips to deal with. Get the ones with a rubber cap cover for disconnect to prevent any shorts while using. You will be amazed how ATV motors will start right up compared to a partially charged battery because at start up most juice goes to the starter robbing the ignition of needed energy to start. Picture does not show the rubber protection caps. I have 3 different types and all work good. I do recommend finding the ones with at least a 8' cord.
Assuming you have a lead acid battery, my recommendation is removing the charger after occasional overnight use. I've seen some batteries overcharged and ruined so trusting the low amperage charger circuitry for continuous use never needs to be tested. This is always sufficient for periods of storage.
Displaying 1 to 11 of 11 posts